Page Comparison

...

1. Deploy the new instances that you will be migrating to from the marketplace:
   1. Deploy in the same VPC as the current SoftNAS instances.
   2. Deploy in the same subnet as the current SoftNAS instances.
   3. Assign the same security groups as the current SoftNAS instances.
   4. Assign the same IAM role as the current SoftNAS instances.
   5. Disable Source/Destination check on the new SoftNAS instances.
2. Set up replication and HA on the new nodes while there are no devices attached.
   1. 'Add Replication' from the Snapreplication menu.
   2. 'Add HA' from the Snapreplication menu.
3. Deactivate replication on the current HA pair you are migrating from.
   1. 'Actions > Deactivate' from the Snapreplication menu.
4. Deactivate replication on the new HA pair that you are migrating to.
   1. 'Actions > Deactivate' from the Snapreplication menu.
5. Copy over the following config files from the current instances to the new instances (each node).

   1. '/etc/exports'

   2. '/etc/samba/smb.conf'

      1. Only copy the shares sections of smb.conf if they exist, do not copy the '[global]' section.

   3. '/etc/target/saveconfig.json'

   4. '/var/www/softnas/config/snapshots.ini'

   5. If you are using tiered pools, copy the below files over:

      1. '/var/www/softnas/config/btier.json'

      2. '/var/www/softnas/config/btier_migrations_saved_sdtiera'
   6. Copy over any custom monitors you may have in '/etc/monit.d/' if they exist.
6. Copy over these config files from current primary instance to the new primary instance for replication to work.
   1. Any snapvol configs in '/var/www/softnas/config/'.
      1. '/var/www/softnas/config/snapvol-*.ini
   2. Copy over only the Relationship1-Tasks from '/var/www/softnas/config/snaprepstatus.ini'
      1. open '/var/www/softnas/config/snaprepstatus.ini' on the current instance in a text editor.
      2. Copy the section labeled '[Relationship1-Tasks]' at the bottom of the file into /var/www/softnas/config/snaprepstatus.ini' on the new primary instance.
      3. Each item mentioned in '[Relationship1-Tasks]' will have a corresponding 'snapvol-*.ini' file associated with it.
7. Power off all instances to migrate the disk devices.
   1. Power off the current instances.
   2. Power off the instances you are migrating to.
8. Migrate the disk devices from the current instances where they are attached to the new instances.
   1. Log into the AWS EC2 console.
   2. Make note of the device order of the current attached disk devices on the current instances.
   3. Detach them all.
   4. Re-attach the devices in the same order and device id to the new instances.
9. Power on the new instances.
   1. At boot time the ZFS pools should be imported and mounted with no user interaction.
10. If using Active Directory, join the new instance to Active Directory at this time.
    1. Follow the instructions in the AD Wizard.
    2. Active Directory Configuration
11. Reactivate replication and HA on the new instances
    1. Go to the Snapreplication menu on the new primary instance.
    2. You should see that the UI looks like its in a 'Snapreplicate Complete' state and is populated as it was on the old instances.
       1. If not, you may have missed a step.
    3. From the 'Actions' menu, select 'Reactivate'
       1. You should see a delta-sync operation then normal replication should pick up where it left off.

...

Related articles

...

...